A practical reference on lyophilized powder: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-01-22 and is reviewed periodically as new material appears.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
The primary structure of Selank is Thr-Lys-Pro-Arg-Pro-Gly-Pro, corresponding to the molecular formula C33H57N11O9 and a monoisotopic mass of roughly 751.9 daltons. The N-terminal threonine and the arginine residue in the fourth position are shared with tuftsin, which carries the sequence Thr-Lys-Pro-Arg. The three additional residues at the C-terminus, Pro-Gly-Pro, extend the chain and are associated with greater resistance to enzymatic degradation. This extension also separates Selank from the shorter parent peptide.
Naming conventions place Selank in the same research family as Semax, another Russian-developed peptide investigated for cognitive effects. The two compounds share a lineage but differ in sequence and in the biological systems proposed as their targets. Semax descends from ACTH fragments, whereas Selank descends from tuftsin. Publications sometimes identify Selank by its full peptide sequence or by laboratory codes rather than one uniform trade name. Because replication outside Russia is limited, reports on its properties are best read alongside the study design and the purity of the material tested.
Selank is a synthetic heptapeptide developed in Russia during the 1990s. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences designed it as a stabilized analog of tuftsin, a naturally occurring immunomodulatory tetrapeptide. The compound has been studied primarily for its reported anxiolytic and nootropic effects. It remains largely unknown in Western pharmacology and is not approved as a medicine by major regulators such as the FDA or the EMA.
Considered radicals by another moderate current of the PCC, they used terrorism to intimidate authorities of the prison system and were withdrawn from leadership in November 2002, when the leadership was taken over by the current leader of the organization, Marcos "Marcola" Willians Herbas Camacho. Marcola would eventually order the deaths of Geleião and Cesinha for having testified to the police, as well as for allegedly leaving the faction and creating a splinter group called the "Terceiro Comando da Capital" (Third Capital Command, TCC), which is now considered to be defunct.
=== Base-pairing === Canonical bases may have either a carbonyl or an amine group on the carbons surrounding the nitrogen atom furthest away from the glycosidic bond, which allows them to base pair (Watson-Crick base pairing) via hydrogen bonds (amine with ketone, purine with pyrimidine). Adenine and 2-aminoadenine have one/two amine group(s), whereas thymine has two carbonyl groups, and cytosine and guanine are mixed amine and carbonyl (inverted in respect to each other).
==== Aerosol mass spectrometer ==== The Aerodyne AMS provides real-time aerosol mass spectrometry analysis of size-resolved mass concentration of non-refractory components (Ex. organics, sulfate, nitrate, and ammonium). The term non-refractory is assigned to species that evaporate rapidly at 600 °C under vacuum conditions (e.g. organic matter, NH4NO3 and (NH4)2SO4. The schematic of a typical AMS is shown in the figure to the right. The Aerodyne AMS is made up of three sections; The aerosol inlet, the particle sizing chamber, and the particle detection chamber. The aerosol inlet has a flow limiting orifice entrance that is around 100 um in diameter. Once in the chamber the sample goes through aerodynamic focusing lens system, which consist of several orifice lenses that are mount in sequence of decreasing inner diameter. The lens focuses the particles into a narrow particle beam. The beam now travels through the particle sizing chamber, where the particle aerodynamic diameter is measured. The particle sizing chamber is made up of a flight tube maintained at (~ 10−5 torr). The entrance of the flight tube is a mechanical chopper that's used to modulate the particle beam; then using both the fixed length of the tube and the time-resolved detection of the arrival at the end, the particles' velocities can be determined. Using the velocity, the particle's diameter is obtained. As the particle beam exits the flight tube, it enters the particle composition detection chamber. In this section, the particles collide with a heated tungsten element (~600 °C).
In 1913, the first electric refrigerators for home and domestic use were invented and produced by Frederick William Wolf Jr. of Fort Wayne, Indiana, with models consisting of a unit that was mounted on top of an ice box. His first device, produced over the next few years in several hundred units, was called DOMELRE. In 1914, engineer Nathaniel B. Wales of Detroit, Michigan, introduced an idea for a practical electric refrigeration unit, which later became the basis for the Kelvinator. A self-contained refrigerator, with a compressor on the bottom of the cabinet was invented by Alfred Mellowes in 1916. Mellowes produced this refrigerator commercially but was bought out by William C. Durant in 1918, who started the Frigidaire company to mass-produce refrigerators. In 1918, Kelvinator company introduced the first refrigerator with any type of automatic control. The absorption refrigerator was invented by Baltzar von Platen and Carl Munters from Sweden in 1922, while they were still students at the Royal Institute of Technology in Stockholm. It became a worldwide success and was commercialized by Electrolux. Other pioneers included Charles Tellier, David Boyle, and Raoul Pictet. Carl von Linde was the first to patent and make a practical and compact refrigerator. These home units usually required the installation of the mechanical parts, motor and compressor, in the basement or an adjacent room while the cold box was located in the kitchen.
== Production == On September 2, 2021, BET+ renewed the series for a second season which premiered on August 11, 2022. On July 6, 2022, BET+ renewed the series for a third season, which premiered on February 23, 2023. On May 30, 2023, BET+ renewed the series for a fourth season, which premiered on May 23, 2024. On October 31, 2024, BET+ renewed the series for a fifth season, which premiered on January 7, 2026. On March 26, 2026, the series was renewed for a sixth season, which will move to Paramount+ after the shutdown of BET+.
Sources: en.wikipedia.org
== Products == ELGA produces water purification systems which provide purified water and ultrapure water for applications in research and analytical laboratories, medical and clinical facilities. It incorporates in its water purifiers a combination of purification technologies, e.g. reverse osmosis, electronics-grade ion-exchange resins, microfiltration, ultrafiltration, degassing, ultraviolet photooxidation and electrodeionization. Products are designed to minimize impact on the environment at all stages - manufacture, in-service and at end of life.
== Awards and fellowships == 1984 ACS Analytical Division's Chemical Instrumentation Award; 1985 Thomson Medal for International Service to Mass Spectrometry; 1990 and 1995 NSF Special Creativity Award; 1991 Frank H. Field & Joe Franklin Award, (ACS Award for Mass Spectrometry); 1997 Fisher Award (ACS Award for Analytical Chemistry); 2006 Distinguished Contribution in Mass Spectrometry Award; 2008 Robert Boyle Prize for Analytical Science; 2012 F.A. Cotton Medal for Excellence in Chemical Research of the American Chemical Society; 2013 Dreyfus Prize in the Chemical Sciences; 2014 ACS Nobel Laureate Signature Award for Graduate Education in Chemistry, shared with graduate student Livia S. Eberlin; 2015 Member, National Academy of Sciences; 2017 Aston Medal, British Mass Spectrometry Society.
Haemophilus is a genus of Gram-negative, pleomorphic, coccobacilli bacteria belonging to the family Pasteurellaceae. While Haemophilus bacteria are typically small coccobacilli, they are categorized as pleomorphic bacteria because of the wide range of shapes they occasionally assume. These organisms inhabit the mucous membranes of the upper respiratory tract, mouth, vagina, and intestinal tract. The genus includes commensal organisms along with some significant pathogenic species such as H. influenzae—a cause of sepsis and bacterial meningitis in young children—and H. ducreyi, the causative agent of chancroid. All members are either aerobic or facultatively anaerobic. This genus has been found to be part of the salivary microbiome.
During sample preparation, the sample buffer, and thus SDS, is added in excess to the proteins, and the sample is then heated to 95 °C for five minutes, or alternatively 70 °C for ten minutes. Heating disrupts the secondary and tertiary structures of the protein by disrupting hydrogen bonds and stretching the molecules. Optionally, disulfide bridges can be cleaved by reduction. For this purpose, reducing thiols such as β-mercaptoethanol (β-ME, 5% by volume), dithiothreitol (DTT, 10–100 millimolar), dithioerythritol (DTE, 10 millimolar), tris(2-carboxyethyl)phosphine or tributylphosphine are added to the sample buffer. After cooling to room temperature, each sample is pipetted into its own well in the gel, which was previously immersed in electrophoresis buffer in the electrophoresis apparatus. In addition to the samples, a molecular-weight size marker is usually loaded onto the gel. This consists of proteins of known sizes and thereby allows the estimation (with an error of ± 10%) of the sizes of the proteins in the actual samples, which migrate in parallel in different tracks of the gel. The size marker is often pipetted into the first or last pocket of a gel.
The first group coexpresses neuropeptide Y (NPY) and agouti-related peptide (AgRP) and has stimulatory inputs to the LH and inhibitory inputs to the VMH. The second group coexpresses pro-opiomelanocortin (POMC) and cocaine- and amphetamine-regulated transcript (CART) and has stimulatory inputs to the VMH and inhibitory inputs to the LH. Consequently, NPY/AgRP neurons stimulate feeding and inhibit satiety, while POMC/CART neurons stimulate satiety and inhibit feeding. Both groups of arcuate nucleus neurons are regulated in part by leptin. Leptin inhibits the NPY/AgRP group while stimulating the POMC/CART group. Thus a deficiency in leptin signaling, either via leptin deficiency or leptin resistance, leads to overfeeding and may account for some genetic and acquired forms of obesity.
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
Reverse-phase HPLC is the usual method and gives a percentage purity value. Mass spectrometry then confirms the molecular mass. Together they provide a basic identity and purity profile for a lot.