heptapeptide comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2025-09-17. Where a claim depends on a specific study, the study is described rather than over-claimed.
Reported activity for Selank centers on anxiolytic and nootropic effects. Russian clinical reports describe use in anxiety and in cognitive or attention-related complaints. Most of this evidence comes from studies conducted by the same research groups that developed the peptide. Independent replication in other countries remains limited, and no major Western regulatory agency has approved the compound for any indication. The gap between local reports and external verification is a recurring point in discussions of the peptide.
Tuftsin, the parent structure, is a naturally occurring immunomodulatory tetrapeptide released from the Fc region of immunoglobulin G by spleen enzymes. Selank extends this four-residue sequence with three additional amino acids. The stated rationale is that the added tail slows enzymatic breakdown and may influence receptor interactions. How the full heptapeptide behaves at the molecular level is not firmly established, and proposed mechanisms often involve indirect modulation of neurotransmitter or immune signaling rather than a single defined target.
Selank is a synthetic heptapeptide developed in Russia. Its sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, a seven-residue chain built around the natural tetrapeptide tuftsin. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences first described the compound in the mid-1990s. The design combined the tuftsin core with an added Pro-Gly-Pro tail, a modification intended to extend the molecule's stability in biological fluids. Published work on the peptide has appeared mainly in Russian-language journals.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic heptapeptide | Modeled on tuftsin |
| Amino acid sequence | Thr-Lys-Pro-Arg-Pro-Gly-Pro | Seven residues |
| Approximate molecular mass | Around 750 Da | Depends on counter-ion and hydration |
| Common forms | Lyophilized powder | Also described as aqueous solution |
| Primary origin of research | Russian laboratories | Mid-1990s onward |
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres is the standard purity method. Mass spectrometry, typically electrospray ionisation, confirms identity through the expected mass-to-charge pattern. Amino acid analysis can verify composition independently. Chiral purity requires separate techniques such as derivatisation followed by chromatographic separation, and such data are rarely reported for research-grade material.
A urine test is any medical test performed on a urine specimen. The analysis of urine is a valuable diagnostic tool because its composition reflects the functioning of many body systems, particularly the kidneys and urinary system, and specimens are easy to obtain. Common urine tests include the routine urinalysis, which examines the physical, chemical, and microscopic properties of the urine; urine drug screening; and urine pregnancy testing.
==== Quantum dot with nanowire in solar cells ==== Another potential use involves capped single-crystal ZnO nanowires with CdSe quantum dots, immersed in mercaptopropionic acid as hole transport medium in order to obtain a QD-sensitized solar cell. The morphology of the nanowires allowed the electrons to have a direct pathway to the photoanode. This form of solar cell exhibits 50–60% internal quantum efficiencies. Nanowires with quantum dot coatings on silicon nanowires (SiNW) and carbon quantum dots. The use of SiNWs instead of planar silicon enhances the antiflection properties of Si. The SiNW exhibits a light-trapping effect due to light trapping in the SiNW. This use of SiNWs in conjunction with carbon quantum dots resulted in a solar cell that reached 9.10% PCE. Graphene quantum dots have also been blended with organic electronic materials to improve efficiency and lower cost in photovoltaic devices and organic light emitting diodes (OLEDs) compared to graphene sheets. These graphene quantum dots were functionalized with organic ligands that experience photoluminescence from UV–visible absorption.
== Trial == Dias' trial started in November 2011. Alcina Dias identified him in court. On 3 October 2014, Dias, was sentenced to three years in jail for the kidnapping of Mendonça during the afternoon of his disappearance. On 18 March 2015, Dias was led to jail by his lawyer, after his arrest warrant had been issued. His sentence was reduced to two years for good behavior. On 29 March 2017, Dias was released.
Sources: en.wikipedia.org
== Neoplasms of uncertain behavior (235–238) == 235 Neoplasm of uncertain behavior of digestive and respiratory systems 236 Neoplasm of uncertain behavior of genitourinary organs 237 Neoplasm of uncertain behavior of endocrine glands and nervous system 237.0 Pituitary gland and craniopharyngeal duct Pituitary adenoma 237.7 Neurofibromatosis 238 Neoplasm of uncertain behavior of other and unspecified sites and tissues 238.4 Polycythemia vera
{\displaystyle \Delta _{\mathrm {r} }G_{T,p}=(\sigma \mu _{\mathrm {S} }^{\ominus }+\tau \mu _{\mathrm {T} }^{\ominus })-(\alpha \mu _{\mathrm {A} }^{\ominus }+\beta \mu _{\mathrm {B} }^{\ominus })+(\sigma RT\ln\{\mathrm {S} \}+\tau RT\ln\{\mathrm {T} \})-(\alpha RT\ln\{\mathrm {A} \}+\beta RT\ln\{\mathrm {B} \})}
=== Differences between PAM and BLOSUM === PAM matrices are based on an explicit evolutionary model (i.e. replacements are counted on the branches of a phylogenetic tree: maximum parismony), whereas the BLOSUM matrices are based on an implicit model of evolution. The PAM matrices are based on mutations observed throughout a global alignment, this includes both highly conserved and highly mutable regions. The BLOSUM matrices are based only on highly conserved regions in series of alignments forbidden to contain gaps. The method used to count the replacements is different: unlike the PAM matrix, the BLOSUM procedure uses groups of sequences within which not all mutations are counted the same. Higher numbers in the PAM matrix naming scheme denote larger evolutionary distance, while larger numbers in the BLOSUM matrix naming scheme denote higher sequence similarity and therefore smaller evolutionary distance. Example: PAM150 is used for more distant sequences than PAM100; BLOSUM62 is used for closer sequences than BLOSUM50.
Sources: en.wikipedia.org
Selank is a synthetic peptide made of seven amino acids. It is modeled on tuftsin, a natural tetrapeptide, with an added three-residue tail. It is not a small-molecule drug.
It originates from research in Russia, associated with the Institute of Molecular Genetics of the Russian Academy of Sciences. The first descriptions date to the mid-1990s. Most published studies come from Russian laboratories.
No, Selank itself does not occur naturally. Its backbone is based on tuftsin, which is produced in the body, but the seven-residue version is a synthetic construct. It is supplied as a manufactured peptide.
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.